1346 NORTH ROAD,
OAKLEIGH SOUTH, VIC , 3167
1800 736 337 or 03 9540 0963

TRW WET TEXTURE

Product Description:

TRW Wet Texture is a 100% RUST FREE trowel applied acrylic decorative finish. TRW Wet Texture comes in a 15-litre bucket, pre mixed ready to use straight from the pail. The texture can easily be tinted to almost any colour from the most popular of colour ranges available.

Application Details:

Before application of any render the surface of the substrate must be clean, dry and free of any debris. This means that any loose or damaged substrate must be removed, or patched and made good, prior to application of the base render. The substrate surface must be cleaned free of any grease, oils, scaling laitance, efflorescence, form-oil compounds, mould, fungi, rust, dirt, dust or any other foreign matter. Pre-painted surfaces must be wire-brushed back to the bare substrate. It is the responsibility of the Builder or Head Contractor to make good any substrate before the render is applied. If such expansion joints are not provided by the Builder or Head Contractor, cracking due to movement of the substrate, may occur. This is in no way indicative of faulty material. Rather it indicates sub-standard building practice. Although TRW Wet Texture is ready to use straight from the pail, The Render Warehouse recommends the texture be agitated with a mixer before use to achieve maximum results.

TRW Texture is to be applied using a steel trowel in a nice tight coat as thick as the aggregate will allow. TRW recommends a 2-man job but understand this can’t always be possible. Whilst the TRW Wet Texture is being trowelled, simultaneous floating of the applied texture is required. This must be done using a plastic float. This floating process is vital in the success of the finished product. A common cause of a damaged job is when the applied texture has been left to long before floating has commenced resulting in a ‘skin’ forming on the texture. This cannot be reversed.

TRW warns TRW Wet Texture should be allowed a minimum 5-7 days to cure completely before any membrane coat is applied. Warranties will be void if this has not taken place.

TRW Wet Texture should only be applied in suitable weather. Rain, freezing, excessive warmth and windy conditions are not suitable conditions for TRW Wet Texture application.

Please note the following

  • Please make sure base coat has been allowed 5-7 days to cure before application of TRW Wet Texture.
  • Failure to do so can have drastic effects on the finished product.
  • The Render Warehouse takes no responsibility if this has not occurred.
  • When TRW Wet Texture is applied according to manufacturers instructions, TRW Wet Texture will cover approximately 10-11 square metres. This may vary due to surface condition and absorption effects.
  • Any addition of sand, water etc. to gain extra metres of application will have negative impact on the product and void any TRW warranty.
  • Prior to texture works commencing, make sure a test panel has been carried out for approval, of both texture and colour, by client.

Safety

  • If swallowed: Rinse mouth and lips with water. Seek medical advice if discomfort occurs.
  • If in Eyes: Flush eyes thoroughly with flowing water for 15 minutes. Seek medical attention symptoms persist.
  • If on skin: Wash thoroughly with soap and water.
  • If Inhaled: Remove subject to fresh air. If symptoms persist seek medical attention.